If a CD changer is attached then this must be disconnected and the cable passed back through the grommet.
#FORD GALAXY DOOR PANEL REMOVAL DRIVERS#
On earlier car's this is normally a standard bolt, later car's it becomes a spline drive boltThe tailgate buffer can now be removed, undo the small screw and remove the cap (Not shown, green arrow) and then the two retaining bolts to remove the buffer:If removing the drivers panel then lift up the storage lid and undo the two big screws. These simply unscrew but may need a small flat blade to act as a lever to assist!The seatbelt mount can now be undone, prise off the rubber cap and then undo the bolt.
If you have the metal panel then extra care must be taken not to bend it!On the bottom of the panel a large plastic screw can be found, one on the N/S card and two on the O/S card. A trim removal tool is useful here but if not the panel can simply be pulled up with care. The plugs are the same fixings that hold the main door cards in place but instead of 'locking' into position, they are used in a compression state instead. The chrome and plastic panels are both fixed the same way by plastic plugs. If both panels are to be removed then the rear tailgate lock panel should be removed, if only one side is to be removed then the panel can be lifted slightly on that side if preferred. The procedure is largely the same for both sides with a few subtle differences:The panels are held in place by a number of screws, clips and adjacent panels. This guide talks through removal of the rear quarter panel 'door' cards.
0 kommentar(er)
